Why does the dash cam shut down shortly after the engine is turned off or before the time setting value is reached?
Please use a multimeter to measure the voltage of the yellow line B+ of the "auxiliary fuse holder" half an hour after the engine is turned off to see if it is lower than the voltage setting value. Please readjust the voltage setting.
Related Articles
After the Smart Box is installed, why does the dashcam didn't switch to parking mode after the engine is turned off?
1. Please check whether the dash cam has parking monitoring detection set to " On " and set the " Storage Space Configuration " to Mode 1 or Mode 3 . 2. Please remove the USB connector of the dashcam , disconnect the black ground wire, reconnect the ...
Why do I have set the time and voltage, but after installing the power line, the battery has insufficient power? Why does it run out of power again after replacing the battery ?
1. Check whether the red / yellow / black (ACC/B+/ ground ) wires of the fuse are connected to the fuse holder correctly. Please refer to the fuse instructions in the installation guide. Connecting the red wire ACC to the fuse that continues to ...
SmartBox Power Management and Parking Mode Guidelines
Power Cut-Off Timing When either the preset voltage or time threshold is reached, the power supply will delay shutdown for 180 seconds before cutting off power. After power is cut, the SmartBox will stop supplying power from the vehicle’s battery to ...
User Manual for Magellan MiVue M820 Pro
Motorcycle dash cameras are essential tools for modern riders, providing added security, ride recording, and evidence in case of accidents or unexpected incidents on the road. This user manual is designed to help you understand the features, ...
Do I need to manually set the date and time on Magellan Dashcam?
The Magellan Dashcam will automatically set the date and time using the GPS signal once a connection is established.